How to make Almost Anything

Week 2: Electronic Production - ISP

0. Setting up Modela milling

log in (fall 2013) - command prompt (fab) - set mill trace (interior 1/64, setting by default) - "view" back, "down", hold and loose end mil, touch board, screw evenly fastened - set x & y, every 20mm check - 3 board-profiles fit on 1 sheet - distance 26mm is good

1. Milling interior in process (10min for interior, 2 min for exterior)

2. Setting up exterior (mill trace 1/32 - back to origin x & y)

3. Print out a large board image and Collect elements

4. Soldering tool sets

Sponge should be wet - copper roll for de-soldering

Start from center to edge

Finish version before programming

5. Programming connection

avrdude done

6. De-solder 0 bridging

Notes

Do not forget washing 1. after milling; 2. after soldering before programming!