<h3>SparkFun Electronics' preferred foot prints</h3> In this library you'll find all manner of digital ICs- microcontrollers, memory chips, logic chips, FPGAs, etc. We've spent an enormous amount of time creating and checking these footprints and parts, but it is the end user's responsibility to ensure correctness and suitablity for a given componet or application. If you enjoy using this library, please buy one of our products at www.sparkfun.com. Licensing: CC v3.0 Share-Alike You are welcome to use this library for commercial purposes. For attribution, we ask that when you begin to sell your device using our footprint, you email us with a link to the product being sold. We want bragging rights that we helped (in a very small part) to create your 8th world wonder. We would like the opportunity to feature your device on our homepage. 32M1-A Micro Lead Frame package (MLF) >NAME >VALUE Thin Plasic Quad Flat Package Grid 0.8 mm >NAME >VALUE Symbol for Atmega328/168/88/48 chips, 32-pin version >NAME >VALUE Atmel 32-pin 8-bit micro, 16k flash. >NAME 1 >NAME >VALUE 1 >NAME >VALUE Wide Plastic Gull Wing Small Outline Package >NAME >VALUE RESISTOR >NAME >VALUE RESISTOR wave soldering >NAME >VALUE >NAME >VALUE SOT 23 >NAME >VALUE CAPACITOR >NAME >VALUE Ceramic Chip Capacitor KEMET 1206 reflow solder Metric Code Size 3216 >NAME >VALUE >NAME >VALUE Small Outline Transistor >VALUE >NAME SMALL OUTLINE TRANSISTOR TS-003 >NAME >VALUE (Black) (Green) >NAME >VALUE >NAME >VALUE >NAME >VALUE >NAME >VALUE >NAME >VALUE >VALUE >NAME G S D PIN HEADER Resistor (US Symbol) Variants with postfix FAB are widened to allow the routing of internal traces MOS FET Supply Symbols GND, VCC, 0V, +5V, -5V, etc. Please keep in mind, that these devices are necessary for the automatic wiring of the supply signals. The pin name defined in the symbol is identical to the net which is to be wired automatically. In this library the device names are the same as the pin names of the symbols, therefore the correct signal names appear next to the supply symbols in the schematic. <author>Created by librarian@cadsoft.de</author> >VALUE SUPPLY SYMBOL Stepper 1 Stepper 2