Here's a model of what I chose to print this week. Basically I used the Makerbot software on Thingiverse to develop an iPhone5 case. I used Inkscape to trace the USMC Eagle, Globe and Anchor design that I put on the back of the case.
First shot of the finished product. It went pretty well. The case clearly fits. It was pretty snug but could probably be a bit tighter of a fit. I think with a rubber sleeve like what Otterbox uses it would be perfect.
Image of the finished case without the iPhone in it. I lost South America somewhere in the print process unfortunately. I think that the isthmus was too narrow and it broke off with the support material. I didn't know at the time that it dissolves, and the bath was broken anyway, so I actually chipped it all out by hand.
