\nOptimized for the 1/64th endmill. Using 17mil for the clearance instead of the absolute minimum of 15.625mils is an easy way to avoid PNG resolution issues. You can drop the clearance to 15.75 or 16 mils if you want but make sure to inspect the path!\n
\n\nThe minimum width is set at 10 mils for now. You can go down to 6, but only if you have a really good reason. By default, use wide traces (such as 16 mils).\n
layerSetup = 1+16 mtCopper = 0.035mm 0.035mm 0.035mm 0.035mm 0.035mm 0.035mm 0.035mm 0.035mm 0.035mm 0.035mm 0.035mm 0.035mm 0.035mm 0.035mm 0.035mm 0.035mm mtIsolate = 1.5mm 0.15mm 0.2mm 0.15mm 0.2mm 0.15mm 0.2mm 0.15mm 0.2mm 0.15mm 0.2mm 0.15mm 0.2mm 0.15mm 1.6mm mdWireWire = 17mil mdWirePad = 17mil mdWireVia = 17mil mdPadPad = 17mil mdPadVia = 17mil mdViaVia = 17mil mdSmdPad = 17mil mdSmdVia = 17mil mdSmdSmd = 17mil mdViaViaSameLayer = 8mil mnLayersViaInSmd = 2 mdCopperDimension = 16mil mdDrill = 16mil mdSmdStop = 0mil msWidth = 10mil msDrill = 0.8mm msMicroVia = 9.99mm msBlindViaRatio = 0.500000 rvPadTop = 0.500000 rvPadInner = 0.500000 rvPadBottom = 0.500000 rvViaOuter = 0.500000 rvViaInner = 0.500000 rvMicroViaOuter = 0.500000 rvMicroViaInner = 0.500000 rlMinPadTop = 0.8mm rlMaxPadTop = 2mm rlMinPadInner = 0.8mm rlMaxPadInner = 2mm rlMinPadBottom = 0.8mm rlMaxPadBottom = 2mm rlMinViaOuter = 0.8mm rlMaxViaOuter = 1mm rlMinViaInner = 0.8mm rlMaxViaInner = 1mm rlMinMicroViaOuter = 4mil rlMaxMicroViaOuter = 20mil rlMinMicroViaInner = 4mil rlMaxMicroViaInner = 20mil psTop = 1 psBottom = 1 psFirst = -1 psElongationLong = 100 psElongationOffset = 100 mvStopFrame = 1.000000 mvCreamFrame = 0.000000 mlMinStopFrame = 4mil mlMaxStopFrame = 4mil mlMinCreamFrame = 0mil mlMaxCreamFrame = 0mil mlViaStopLimit = 0mil srRoundness = 0.000000 srMinRoundness = 0mil srMaxRoundness = 0mil slThermalIsolate = 1mm slThermalsForVias = 0 dpMaxLengthDifference = 10mm dpGapFactor = 2.500000 checkGrid = 0 checkAngle = 0 checkFont = 1 checkRestrict = 1 useDiameter = 13 maxErrors = 50