CAPACITOR >NAME >VALUE >NAME >VALUE RESISTOR >NAME >VALUE RESISTOR wave soldering >NAME >VALUE >NAME >VALUE LED 1206 pads (standard pattern) >NAME >VALUE LED1206 FAB style (smaller pads to allow trace between) >NAME >VALUE 5mm round through hole part. >NAME >VALUE >NAME >VALUE SOT 23 >NAME >VALUE Small Outline Package >NAME >VALUE Dual In Line Package >NAME >VALUE HP-VFQFP-N20 Micro Lead Frame package (MLF) >NAME >VALUE 1 >NAME >VALUE 1 >NAME >VALUE PIN HEADER >NAME >VALUE 1 non-polarized capacitor >NAME >VALUE >NAME >VALUE LED >NAME >VALUE >NAME >VALUE >NAME >VALUE >NAME >VALUE >VALUE >NAME >NAME >VALUE >NAME >VALUE MISO SCK RST VCC MOSI GND Resistor (US Symbol) Variants with postfix FAB are widened to allow the routing of internal traces LED >VALUE >VALUE SUPPLY SYMBOL SUPPLY SYMBOL RESISTOR >NAME >VALUE RESISTOR wave soldering >NAME >VALUE >NAME >VALUE >NAME >VALUE Resistor (US Symbol) Variants with postfix FAB are widened to allow the routing of internal traces CAPACITOR >NAME >VALUE >NAME >VALUE non-polarized capacitor >NAME >VALUE Supply Symbols GND, VCC, 0V, +5V, -5V, etc. Please keep in mind, that these devices are necessary for the automatic wiring of the supply signals. The pin name defined in the symbol is identical to the net which is to be wired automatically. In this library the device names are the same as the pin names of the symbols, therefore the correct signal names appear next to the supply symbols in the schematic. <author>Created by librarian@cadsoft.de</author> >VALUE SUPPLY SYMBOL