First time using a mill to make circuit boards. Here is the standard fab class hello world board which was easy to put together and program using the class resources.





Here is a more complex board I put together to test the mega88 and a motor controller chip for the final project. A good amount of work went into the layout of this board (about the time it would take to send out a two layer board%E2%80%A6)





The programmer shown here is the super simple bsd programmer which is great fun if you have a parallel port to use it on%E2%80%A6 One note when using this programmer, the reset pin will be held low until the programmer is removed. This just adds one more step to the dev cycle.





And then my hard disk, thinkpad, and parallel port died :(