As a beginner to designing my own PCB board in Eagle, it took me a long time to figure out how to import different components into my schematics (above) and wire them correctly. Later I found out that I made a mistake in connecting my switch button; it should not be connected to VCC. This is to be fixed soon.

I exported the top layer of my board (check 'monocrhomatic' option when exporting) and printed it using Modela in the exact same way I completed Week3 assignment.

The components that I needed are as stated in the image above although I accidentally omitted 1KΩ Resistor. The FTDI SMD Header pins can be broken into however many pins are needed. In this assignment, I only needed 6.

As always, I started off by soldering small parts such as ATtiny44, resistors, capacitors, and the LED. All of thoese components did not matter of direction (not even the LED). And here is the finished board! :)

WEEK 6: ELECTRONICS DESIGN

Part1: PCB Designing in Eagle

Part2: Soldering Components onto the Board