Kenny Friedman, Week 03
Electronics Production
PCB Creation
I used the Roland mono-fab mill and soldered lots of very small components by following Brian's PCB instructions. Everything worked as intended, and I even got the soldering working on the first try! It's not the prettiest, but it gets the job done.
I was very nervous about breaking the mill bits, so I might have gone too slowly, but happily, I did not break anything. The trickiest part of the week was soldering very small components to the board, but eventually I made a contact that was "shiny and smooth"!
PCB Production Photos
![](./img/IMG_0797.jpg)
![](./img/IMG_0798.jpg)
![](./img/IMG_0800.jpg)
![](./img/IMG_0802.jpg)
![](./img/IMG_0803.jpg)
![](./img/IMG_0804.jpg)
![](./img/IMG_0806.jpg)
![](./img/IMG_0808.jpg)
![](./img/IMG_0810.jpg)
![](./img/IMG_0811.jpg)
![](./img/IMG_0814.jpg)
![](./img/IMG_0816.jpg)