>NAME >VALUE >Value >Name >Name >Value >Name >Value >Name >Value 1 >NAME >VALUE <b>PIN HEADER</b> >NAME >VALUE 1 <b>CAPACITOR</b> >NAME >VALUE >NAME >VALUE <b>RESISTOR</b> >NAME >VALUE <b>RESISTOR</b><p> wave soldering >NAME >VALUE >NAME >VALUE ATmega8U2/16U2/32U2 USB microcontroller >NAME USB >Name >Value >NAME >VALUE MISO SCK RST VCC MOSI GND non-polarized capacitor >NAME >VALUE >NAME >VALUE SMD micro USB connector as found in the fablab inventory. Three footprint variants included: <ol> <li> original, as described by manufacturer's datasheet <li> for milling with the 1/100" bit <li> for milling with the 1/64" bit </ol> <p>Made by Zaerc. <b>Resistor (US Symbol)</b> <p> Variants with postfix FAB are widened to allow the routing of internal traces <ABRACON - ABLS-16.000MHZ-B2-T. - CRYSTAL, 16MHZ, 18PF, HC-49US</b><p> <author>Created by SamacSys</author> <b>ABLS</b><br> >NAME >VALUE >NAME >VALUE <b>ABRACON - ABLS-16.000MHZ-B2-T. - CRYSTAL, 16MHZ, 18PF, HC-49US</b><p> Source: <a href="http://www.abracon.com/Resonators/abls.pdf"> Datasheet </a> <b>Supply Symbols</b><p> GND, VCC, 0V, +5V, -5V, etc.<p> Please keep in mind, that these devices are necessary for the automatic wiring of the supply signals.<p> The pin name defined in the symbol is identical to the net which is to be wired automatically.<p> In this library the device names are the same as the pin names of the symbols, therefore the correct signal names appear next to the supply symbols in the schematic.<p> <author>Created by librarian@cadsoft.de</author> >VALUE >VALUE <b>SUPPLY SYMBOL</b> <b>SUPPLY SYMBOL</b> Since Version 8.2, EAGLE supports online libraries. The ids of those online libraries will not be understood (or retained) with this version. Since Version 8.3, EAGLE supports URNs for individual library assets (packages, symbols, and devices). The URNs of those assets will not be understood (or retained) with this version.