const int Thumb = 3;
const int Index = 2;
const int Middle = 1;
const int Ring = 9;
const int Pinky = 8;
const int sensor = 0; 
const int ledPin = 10;

void setup() {
  // put your setup code here, to run once:
  pinMode(ledPin, OUTPUT);
//  pinMode(Thumb,OUTPUT);
  pinMode(Index,INPUT);
  pinMode(Middle,INPUT);
  pinMode(Ring,INPUT);
  pinMode(Pinky,INPUT);
  Serial.begin(115200);
}

void loop() {
  //Turn on the LED to show the beginning of a cycle
  digitalWrite(ledPin,HIGH);
  //Run through each finger, reading the sensor value for each

//  digitalWrite(Thumb,HIGH);
//  int thumb = analogRead(sensor);
//  thumb = map(thumb, 195, 218, 0, 90);
//  Serial.print(thumb);
//  Serial.print(",");
//  Serial.println("Thumb");
//  delay(7);
//  digitalWrite(Thumb,LOW);
//  delay(7);

  digitalWrite(Index,HIGH);
  int index = analogRead(sensor);
  index = map(index, 120, 190, 0, 100);
  Serial.print(index);
  Serial.print(",");
  Serial.println("Index");
  delay(7);
  digitalWrite(Index,LOW);
  delay(7);

//  digitalWrite(Middle,HIGH);
//  int middle = analogRead(sensor);
//  middle = map(middle, 80, 105, 0, 100);
//  Serial.print(middle);
//  Serial.print(",");
//  Serial.println("Middle");
//  delay(7);
//  digitalWrite(Middle,LOW);
//  delay(7);
//
//  digitalWrite(Ring,HIGH);
//  int ring = analogRead(sensor);
//  ring = map(ring, 70, 95, 0, 100);
//  Serial.print(ring);
//  Serial.print(",");
//  Serial.println("Ring");
//  delay(7);
//  digitalWrite(Ring,LOW);
//  delay(7);
//
//  digitalWrite(Pinky,HIGH);
//  int pinky = analogRead(sensor);
//  pinky = map(pinky, 175, 198, 0, 100);
//  Serial.print(pinky);
//  Serial.print(",");
//  Serial.println("Pinky");
//  delay(7);
//  digitalWrite(Pinky,LOW);
//  delay(7);

//
//  digitalWrite(ledPin,LOW);
//  delay(1);
  //
}