Computer-Controlled Machining

I got super sick this week and I wasn't able to finish this week until the last week of the course. I didn't have time to fully sand down and assemble all the pieces but here's what I have.

CAD

This part was so difficult. I chose a way too complicated design and had a ton of notches and parameters to get right.

This the final CAD of the piece.

Cutting it Out

Because I missed the week where this is done I had to cut it out in N51 in the architecture wood shop. Their machine is so much cooler than the one in the EECS section. The vacuum suction itself is so cool.