Week 12: Interface Programming

This would be a good week to make progress on my final project

Issues that I faced

• Bad Set Screw in SRM (possibly stripped)
• Milling on a stock that was mostly cut out or small stock without sufficient tape
• There is more give in pin to socket connect than I would like
• My brain is stupid (That is more of a personal thing)
• There was short between the i2c lines on one of my original boards. I carved away the extra copper and the multimeter did not read continuity between the two lines but I still had the same issue and when I milled a new board the problem disappeared
• I was getting issues sending a lot of data over multiple transmissions over i2c