this week we had to mill and stuff an in-circuit programmer.
jen @ archshops sent me my board and components as I was stuck in ri.
refer to wk5 for milling.
boy those components were tiny!
this was my first time soldering surface-mount components too.
grateful for the tutorial video on the archshops site
and these htmaa resources.
this is where i worked in my basement.
key tools:
rubbing alcohol to clean the pcb.
tweezers for teeny things.
loupe headband (thnks will).
breathing exercises
flash the programmer
usb to pc, 10-pin to AMD programmer
AMD programmer
ebdg in terminal
demircan helped flash my D11C thru the AMD bootloader.
success!
trying to flash again, we receive an error:
"more than one debugger found"
which verifies that its loaded.
connected to another D11C
another test:
trying to program Dermican's board
with my D11C.
ebdg in terminal
success!
demircan's board recieved the boot.
did i understand any of that? no
need to look at edbg, and cmsis dap