Andrew Manto
howtomakealmostanything
Home Week 01 Final Project Proposal Week 02 Laser Cutting Press Fit Week 03 Integrated Circuit Programming Week 04 3d Printing and Scanning Week 05 Circuit Board Design Week 06 Molding and Casting Week 07 Programming Week 08 Make Something Nice Week 09 Input Devices Week 10 Composites Week 11 Output Devices Week 12 Interface and Application Programming Week 13 Networking Week 14 Final ProjectWEEK 05 // Circuit Board Design
The link here was an invaluable resource to getting the exercise completed!
This image is the trace file that I generated using Eagle. Pretty straigtforward, just a matter of moving around a few of the traces and adding a few others.
I also generated a cut-out path on a seperate layer that I used to extract my finished board from the waster sheet.
Here is an image of the fab module that I used when sending information to the Modela milling machine. It was super simple to send the files [much easier than Mastercam]. I made sure to save my origin [15, 57] for my cutout pass.
Did it