Electronics Production / In-circuit Programmer

In this assignment, I milled amd soldered a circuit board to make an in-circuit programmer. The first attempt at milling went a little wrong because i set the orign to far along the x axis - Corrected this problem then got a good result.

I was able to make a sucessful programmer, show up on in terminal. Then i changed the makerfile to PROGRAMMER? = usbtiny, and connected the two devices with a female six pin cable that Eytan helped me make. However the programmer couldn't locate my flash device. I checked the resistors, diodes and shorting possibilities but couldn't find the solution. So in the end wasn't able to program the second programer with the first programmer.