02 Electronics Production
PROGRAMMER PCB
![](../data/week2/cover.jpg)
![](../data/week2/mill-setup.jpg)
![](../data/week2/milling.jpg)
![](../data/week2/mill-done.jpg)
First the milling procedure was setup using MODS with pngs offset by 4. Next, the original point was set and the milling initiated. The result was 😚👌!
![](../data/week2/pcb-components.jpg)
Next came the actual soldering. After finding the components, I started soldering. I found that you need to first apply the soldering iron to the both the components and board before adding just a tiny bit of lead.
![](../data/week2/programming-successful.jpg)
Finally, it was time to load the programmer. It worked!