Jenny Moralejo (HTMAA 2019) Week 01 Week 02
Vinyl Cutting Laser Cutting
Week 03 Week 04 Week 05 Week 06 Week 07 Week 08 Week 09 Week 10 Week 11 Week 12 Week 13 Week 14 Final Project
Week 12

Mechanical Machine Design

EECS Makes a Drink Mixing Machine

My Contributions

For this week I was in charge of the entire documentation on the website for the section. You can find the documentation here.

Besides documenting and writing the website for the project, I 3D printed the cupholder top and bottom for the machine and crimped and snipped telephone wires. The wires were made by cutting ~10 inch wires, stripping ~1cm off of each end, inserting them into a 4 pin tool, and crimping them. The parts were then tested with a multimeter to ensure connectivity.

top of cupholder 3d print wires and cutting final small telephone wire

You can find a video of the final working project below!